![]() 3. Select Diagnostic > appropriate vehicle Refer to Service Programming System (SPS) Description and Service Programming System (SPS) (Remote Procedure) or Service Programming System (SPS) (Pass-Thru Procedure) in this section.ġ. Connect the Tech 2 to the vehicle DLC, with theĢ. Turn ON the Tech 2. Important: If an updated software/calibrations is released, DO NOT program the VIN now. Refer to Service Programming System (SPS) Description and Service Programming System (SPS) (Remote Procedure) or Service Programming System (SPS) (Pass-Thru Procedure) in this section. Vehicle Identification Number (VIN) Programming Procedure Important: If the ECM from another vehicle is installed, VIN is not programmed by the Tech 2. ![]() 2. Put on the ECM to the bracket and tighten by aģ. Refit the instrument cover by four screws. 4. Disconnect the two connectors from the ECM.ġ. Connect the two connectors to the ECM. Service Programming System (SPS) Description and Service Programming System (SPS) (Remote Procedure) or Service Programming System (SPS) (Pass-Thru Procedure) in this section.ġ. Disconnect the negative battery cable. Latest software/calibrations if released.Engine Control Module (ECM) Replacement Procedure Important: If the ECM is to be replaced the following programmed contents MUST be reprogrammed into the new ECM.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |